Internet and network commands
(Redirected from Network command)
Jump to navigation
Jump to search
ethtool | command to show if a network cable is plugged in e.a. |
ftp | Used to establish a connection with a specified host using the File Transfer Protocol. |
ifconfig | Displays/establishes information about the network interfaces. |
ifup | Bring up network interface. |
ifdown | Bring up network interface. |
iptraf | Interactive IP LAN monitor |
iwconfig | Displays/establishes information about the wireless interfaces. |
ip | Used to manage IP network interfaces. |
lsof | Command to show what processes are making use of a port e.a. |
nmap | Command to show which ports are open e.a. |
netstat | Displays information about the Linux networking subsystem. |
nslookup | Looks up the numerical IP address of the specified host. |
ping | Sends a packet to a designated address and waits for a response. |
route | Configure IP4 routing |
scp | Copy files over the network. |
showmount | Displays the Network Filesystem mounts available. |
smbclient | Launches an interactive samba utility which resembles ftp. |
smbmount | Mounts a remote Samba service at the specified mount point. |
smbumount | Unmounts the specified Samba mount point. |
ssh | Control a remote computer over the network. |
telnet | Opens a terminal window on the remote host and starts an interactive session. |
traceroute | Prints the route that packets take to network host |
wvdial | Initiates a PPP dial-up connection. |